Dual Temperature Controller
Craft brewers recognise temperature management is essential for achieving repeatable beer and wine taste. Cheese makers recognise this controller can allow them to make cheese all year round by using a temperature controlled refrigerator instead of packing boxes with ice to produce their cheese. Salami makers recognise the need to control temperature and case hardness with fermented foods. Whether you are a beer maker, wine maker, cheese maker, or salami maker, a digital temperature controller is well suited to these tasks.
It comes fully mounted in an enclosed housing and tested to Australian Standards so it is safe and immediately ready for use. This controller can be used for both heating and cooling. It has dual rear sockets for a heating device and a cooling device. If you are a home brewer or cheese maker it is ideal all year round.
The simplest of heating sources such as a heating pad or heating belt can be used with this controller. Why run a heating device 24/7 when you don't need to? With this controller the heating source is only powered on when the lowest set temperature is reached and when it gets to your highest set temperature it powers off. It works the same way for cooling. No additional wiring or probes required. Plug it in, set and forget.
- Temperature Control Range: -50-99ºC (-58-210ºF)
- Power Supply: 220V AC +/- 10%, 50/60HZ
- Relay Contact Capacity: Cooling (10A/250V AC), Heat (10A/250V AC)
- Sensor: NTC Sensor
- Accuracy: +/- 1ºC (-50-70ºC or -58-158ºF)
- Ambient Temperature: 0-50ºC (32-122ºF)
- Cable length: 1.8m